A/C Pro

Arctic Freeze

Arctic Instructions 1

TURN ENGINE & A/C ON

Start car and turn on A/C to its highest settings, MAX-COOL.

Arctic Instructions 2

DETERMINE IF COMPRESSOR IS ON

With A/C on, determine if compressor clutch is engaged (cycled on).

TIP – If the compressor is not cycling on, add ½ can of refrigerant using instruction 5-8.
If the compressor still does not engage, repairs may be necessary.

Arctic Instructions 3

FIND SERVICE PORT

Locate the vehicle’s low pressure port on the larger diameter aluminum tubing, between the compressor and evaporator. Remove the plastic cap from port and save. Visit our port locator for help locating your low pressure service port.

Arctic Instructions 4

REMOVE SHIPPING DISK

Unscrew trigger dispenser from can and set can aside. Remove red & white shipping disk by unscrewing and discard.

Arctic Instructions 5

ATTACH QUICK COUPLER

Attach the quick coupler fitting on end of recharge hose to the low pressure port (only port it will fit on to) by pulling the connector ring back as you push the fitting on to the low pressure port. DO NOT PULL TRIGGER as it will release refrigerant from the vehicle.

Arctic Instructions 6

READ PRESSURE

Rotate the blue dial on the gauge until the?center arrow in the “V” on the clear plastic lens points to the ambient (outside) temperature (if temperature is between 85°-115°F, point red arrow at 85°F). Read pressure when the clutch is engaged. If the gauge needle is past the “V” please read instruction #2. If the gauge needle is before the “V” please read instruction #7. If the compressor is cycled on and the pressure is in the red, do not attempt to recharge. Seek professional help.

Arctic Instructions 8

CHARGE

Pull ring back to disconnect recharge hose from vehicle and screw can on to recharge hose (CAN IS NOW READY FOR USE). DO NOT REMOVE TRIGGER FROM CAN UNTIL EMPTY. Reconnect quick coupler to low pressure port. Shake can well. Hold can upright to charge, shaking and rotating from 12 o’clock to 3 o’clock every few seconds. Squeeze trigger to dispense contents. Continue process, releasing trigger every 10 – 15 seconds to check system pressure with the “V” range on gauge. Continue this process until the system is fully charged (PSI is in GREEN zone) or can is empty. BE CAREFUL NOT TO OVERCHARGE YOUR SYSTEM.

Arctic Instructions 8

COMPLETION

It is possible that the can will not be empty when finished. In this case, after disconnecting from vehicle, simply leave the recharge hose on the can and store in a cool dry location. If the can is empty, hold upside down for one minute to dispense any remaining product. Disconnect from vehicle and simply unscrew the can and discard. The recharge hose may be used again with any R-134a can with a threaded cap. Replace the plastic cap you removed from port during instruction #3.